In this home repair video, Bob Schmidt shows you how to check to see if your level is still accurate.
Just updated your iPhone to iOS 18? You'll find a ton of hot new features for some of your most-used Apple apps. Dive in and see for yourself:
- Hot
- Latest
-
How To:
Remove a Shark Bite Fitting Without a Special Tool - Adjustable Wrench Trick
-
How To:
Tighten radiator valves
-
How To:
Cut the perfect inside corner with a miter saw
-
How To:
Build an industrial size BBQ smoker from an old refrigerator
-
How To:
Install a T-Mold Transition Between Laminate & Ceramic Tile
-
How To:
Check out foundation cracks below your carpet
-
How To:
Fit door handles to a door properly
-
How To:
Build and install a cheap dumbwaiter in your home
-
How To:
Adjust the Alignment of Cabinet Doors
-
How to Build a Shed, Part 11:
Installing Fascia Boards & Soffit Materials
-
How To:
Install a window in a metal frame
-
How To:
Clean and Maintain Your Tape Measure
-
How to Build a Shed, Part 9:
Building & Installing Gable Ladders (Rakes)
-
How To:
Cut Perspex or acrylic sheet with a circular or jigsaw
-
How To:
Build a simple beam bridge
-
How To:
Build a rolling tool cabinet
-
How To:
Install a towel bar on a bathroom wall or hollow door
-
How To:
Lay bricks with joint spacers
-
How to Build a Shed, Part 15:
Installing Exterior Wood Trim
-
How To:
Install a piano hinge on a side door
-
How To:
Remove a Shark Bite Fitting Without a Special Tool - Adjustable Wrench Trick
-
How To:
Tighten radiator valves
-
How To:
Cut the perfect inside corner with a miter saw
-
How To:
Build an industrial size BBQ smoker from an old refrigerator
-
How To:
Install a T-Mold Transition Between Laminate & Ceramic Tile
-
How To:
Fit door handles to a door properly
-
How To:
Check out foundation cracks below your carpet
-
How To:
Build and install a cheap dumbwaiter in your home
-
How To:
Adjust the Alignment of Cabinet Doors
-
How to Build a Shed, Part 11:
Installing Fascia Boards & Soffit Materials
-
How To:
Install a window in a metal frame
-
How to Build a Shed, Part 9:
Building & Installing Gable Ladders (Rakes)
-
How To:
Clean and Maintain Your Tape Measure
-
How To:
Build a simple beam bridge
-
How To:
Cut Perspex or acrylic sheet with a circular or jigsaw
-
How To:
Build a rolling tool cabinet
-
How To:
Bleed Trapped Air from Baseboard Heater
-
How To:
Make a Floating Shelf (Awesome Pallet Wood Project)
-
How to Build a Shed, Part 15:
Installing Exterior Wood Trim
-
How To:
Make & Install a Concrete Post
1 Comment
I didn't know levels had to be calibrated, will try this.
Share Your Thoughts